Hospitals and Healthcare Boiler Rentals
Temporary and Emergency Boiler Rentals for Hospitals in New York, New Jersey and Connecticut
Our rental boilers have been used by hospital networks, nursing homes and assisted living facilities across Manhattan, Brooklyn, Queens, the Bronx, Staten Island, Long Island, Westchester, Northern New Jersey and Fairfield County, Connecticut. Facilities call on us for:
- High pressure steam for heating, sterilization and central sterile processing (CS/SPD) equipment
- Low pressure steam for heating
- Hot water for patient care areas, in-house laundry, food service and domestic use
Contact Us
Need a Boiler Fast?
24/7 emergency and temporary boiler rentals for hospitals and healthcare facilities across NY, NJ and CT.
Why Hospitals Need a Rental Boiler
A hospital cannot run on a broken boiler. Heat, hot water and sterile equipment all depend on it, and a plant failure quickly turns into a patient care and life safety issue. Even a short boiler outage can disrupt patient care, sterilization, food service, laundry operations and domestic hot water. Emergency and Temporary boiler rentals allow hospitals to maintain critical building systems while permanent equipment is repaired or replaced.
Most calls we get from hospitals and healthcare facilities fall into a few categories:
- Sudden failure from a tube leak, dry fire or controls fault
- A boiler condemned at inspection and waiting on repair or replacement
- A planned shutdown of the central plant for a capital project or fuel conversion
- New construction or added bed capacity that needs heat before the permanent plant is ready
- Backup capacity needed ahead of a Joint Commission or Department of Health survey
- Severe weather putting a single boiler plant at risk during flu season or a cold snap
Why Hospitals & Healthcare units Choose Mobile Steam Boiler Rental Corp
- Over 50 years working with hospitals, nursing homes and assisted living facilities in the region
- Fleet based in Mt. Vernon, Westchester and Putnam County
- 24/7 for emergency response
- Units arrive piped, wired and fused, with a technician on site for startup and staff training
- We handle FDNY, DOB and DOT permitting in New York City, and the equivalent requirements in New Jersey and Connecticut
- Sizes from 20 to 800 HP, high and low pressure, steam or hot water, natural gas or No. 2 fuel oil
- Fuel tanks, heat exchangers, pumps and deaerators available if your job needs them
- Certificates of insurance provided naming your facility as additional insured
- We plan the boiler site with your team so it stays clear of patient areas, ambulance routes and air intakes
Serving Hospitals and Healthcare Systems Across New York, New Jersey and Connecticut
We respond to hospitals and healthcare facilities in Manhattan, Brooklyn, Queens, the Bronx, Staten Island, Long Island, Westchester and the Hudson Valley. In New Jersey we cover Newark, Jersey City, Hoboken, Bergen County, Edison and New Brunswick. In Connecticut we serve Stamford, Norwalk, Fairfield, Greenwich, New Haven and Hartford. Get in touch with Mobile Steam Boiler Rental Corp, For Emergency or Temporary Boiler Rentals for Hospitals across these areas.
Hospital and Healthcare Boiler Rental FAQs
How fast can you get a temporary boiler to our hospital in an emergency?
Setup can take as little as 12 hours, though it depends on travel time, site access and the complexity of the installation. Call as soon as the outage is confirmed so equipment and crews can be dispatched right away.
Can a rental boiler supply the high pressure steam our sterile processing department needs?
Yes. Our fleet includes high pressure steam boilers suitable for sterilizers and autoclaves in CS/SPD, along with the heating and domestic hot water loads for the rest of the building.
Will a temporary boiler affect our Joint Commission or Department of Health survey?
A properly installed rental boiler gives you documented backup capacity for heat, hot water and sterilization, which supports survey readiness rather than creating a gap. We provide insurance certificates and startup documentation your team can keep on file.
How do you handle permits for hospital campuses in New York City, New Jersey and Connecticut?
We manage the permitting process specific to each jurisdiction, including FDNY, DOB and DOT approvals in NYC and the applicable requirements in NJ and CT, so your facilities team does not have to navigate it alone.
Where can the temporary boiler be sited on our campus?
The unit needs a level, paved area near the boiler room entrance, at least 15 feet from air intakes or open windows, and fenced off from pedestrian traffic. We work with your facilities and security teams to find a spot that does not interfere with patient areas or ambulance access.
Who operates the rental boiler once it is installed?
Your staff handles day-to-day operation. A Mobile Steam technician oversees startup and trains a designated staff member on running the equipment. If your facility requires a certified high pressure operator on watch, we can help source one.
What size boiler does a hospital or nursing home typically need?
It depends on bed count, square footage and sterilization load. We size units by horsepower, PSI and expected hot water usage. The fastest way to get an accurate recommendation is to have our team review your facility’s current boiler nameplate and usage.
How much does a hospital boiler rental cost?
Pricing depends on size and scope. A quote typically includes the rental rate, trucking, installation and disconnection, startup, staff training and permitting. Larger facilities with high steam demand should expect pricing on the higher end of the commercial range.